TWIN PIN-H

With the Twin-Pin Series, vhi provides an anchoring system that only spread once the insulation has been installed. As a result the adjustment work on the block insulation is minimized. Once the insulation has been put into position, the supplied washer is pushed over the anchor arms and the ends of the anchor are bent apart using two pipes. To make work easier, the two ends of the anchor are of different lengths. The washer is the abutment for this operation and also presses the block insulation against the substructure.

Type H of the Twin-Pin Series is designed for mounting using manual welding and therefore has a base which is at an angle of 90°.

vhi supplies the Twin-Pin H Series in three versions:

STH
Anchor without corrugation that can be used for simple anchoring tasks, such as for low wall thicknesses or in tub positions.

CTH
Corrugated anchor for average to difficult applications; the depth of the corrugation basically corresponds to the single diameter of the wire so that there is good transmission of the retention forces to the refractory concrete.

HTH
This type of anchor has a more pronounced corrugation. This produces yet better transmission of the retention forces to the refractory concrete.